How to control the breakage rate of stone

- Sep 27, 2020-

From the stone processing to mechanical equipment requirements, stone cutting must use infrared cutting machine cutting, can effectively avoid exploding edge and other problems;Stone parquet to be customized by the manufacturer, with a professional water knife cutting, and the designer is related to the division of the seam to be reasonable;

 

Stone factory before the six sides of protection is certainly to do, but do a good job (distinguish between the quality of protective agent, category), the standard is not the same, you can ask the manufacturer for inspection;

In fact, the transportation link is the biggest link of stone breakage, stone plate packaging is the key!Packaging can be divided into wooden cases and boxes with straw rope. It is not recommended to pack white stone with straw rope, because straw rope will pollute the yellow stone.

The wooden case should be packed with the flat plates facing each other, and the installation sequence should be placed in the case lined with moisture-proof paper, with 50mm foam strips spaced.

Stones above 800mm should be stored vertically.Cases shall be provided with iron waist straps at both ends, and with iron cladding corners on the lateral rails.

 

In transportation, handling and loading and unloading shall comply with the following provisions:

Transport requirements:

(1) When handling, it should be loaded lightly, and it is strictly prohibited to fall and roll. When placing upright, the back edge must touch the ground first;

(2) When the area of a single stone plate exceeds 0.25 square meters, it shall be transported upright. When handling large products with lifting tools, the stressed edges shall be cushioned;

(3) When loading and unloading with lifting equipment, it is advisable to lift one box each time;

(4) Loading and unloading shall be carried out in accordance with the requirements of storage. Smooth transportation is required and collision is strictly prohibited.

 

Storage requirements:

(1) Stone plates should be stored indoors, and outdoor storage must be covered.

(2) When the plates are placed in upright position, the surface should be relatively smooth, the tilt degree should not be more than 15°, the stack height should be 1.6m, the bottom and the layer must be supported by pollution-free elastic material;

(3) When the board cannot be stacked upright, it should be smooth and opposite, the ground should be flat and firm, the cushion points between layers should be on the same vertical line, and the height of the stack should be 1m.

(4) After the packaging of the product, the stow height of 2m is appropriate.